China wholesale Har H103 Neck Guide to Barcelona Manufacturers
China wholesale Har H103 Neck Guide to Barcelona Manufacturers Detail:
More details:
Product detail pictures:
The corporate upholds the philosophy of "Be No.1 in quality, be rooted on credit rating and trustworthiness for growth", will proceed to serve aged and new buyers from home and abroad whole-heatedly for China wholesale Har H103 Neck Guide to Barcelona Manufacturers, The product will supply to all over the world, such as: Latvia, Tanzania, Luxembourg, We have now a strict and complete quality control system, which ensures that each product can meet quality requirements of customers. Besides, all of our products and solutions have been strictly inspected before shipment.
Wire Belt of Londonderry, NH looked to Sullivan Construction to build an addition to their facility – David Greer, of Wire Belt tells you his opinion with working with Sullivan Construction.
Garage quoted 5 hour billable repair + parts…. two new bushes cost £10 +VAT each, 1st side (nearside) was as you’d expect takes longer as it’s learning as to just how few bolts taken off you can get away with 
1) Drive up front wheels on my big ramps
2) Two wheels with tyres stacked (flat) on road just behind front wheels on the road, 6″ x 4″ two foot long wooden blocks positioned between wheels and the ‘jack point’ car body area, to get the wood under the car (one side at a time) the rear of the car body was jacked up just in front of the rear wheels.
3) Front offside suspension jacked up, offside ramp pulled clear, offside wheel removed
4)
3) Front (forwards facing) lower suspension ‘swing arm’ bolt, 18mm head, with a LOT of thread to come out ‘in/out’ ratcheting and WD40 was needed to ‘clean’/free thread
4) Three bolts on bottom ball joint freed, ’3 nut’ metal plate lifted off, rubber hammer used to free (internal) the ball joint from swinging arm, a bit of pulling/turning of steering/brake to clear (same issue re-fitting)
5) Swinging arm (front end first) wiggled free, once front clear, pulled/wiggled forward to clear from old ‘dead’ suspension bush
6) Air saw/Air chisel hammering with wood chisel, cutting out remaining rubber where needed etc etc to get out ‘plastic’ of old bush!
7) Red rubber grease new bush/alloy subframe bush hole
8) Power wire brushed swinging arm and underbody painted
9) Stainless Steel laser cut ‘discs’ with SS washers & M16 shaft bolt used to drive new suspension bush (step by step) into subframe
10) Wiggle/Push etc. swinging arm rear ‘hex stud’ into the new bush
11) Lever/push/wiggle the front of the swinging arm in to pressed steel ‘box’
12) Replace swinging arm main bolt
13) Ball joint re-bolted, wheel back on check all bolts etc and test drive
Long forward facing 18mm head bolt (in/out ratcheting with WD40 to ‘clean’/free thread
By Bess from Ukraine - 2016.10.25 15:53
This company can be well to meet our needs on product quantity and delivery time, so we always choose them when we have procurement requirements.
By Fay from Kenya - 2016.08.15 12:36