China Wholesale for The Har-1400 of multiflex conveyor chains to Japan Manufacturer
China Wholesale for The Har-1400 of multiflex conveyor chains to Japan Manufacturer Detail:
Pitch:82.5(mm)
Shaft diameter:9.5(mm)
Thickness:28.6(mm)
Working load:4700(N)
The material of the Multiflex conveyor chains are POM and all of them have a transport direction of flexibility, low coefficient of friction and has long lifetime. The characters of the products are easily installation and maintenance and high mechanical strength as well as excellent product handling. Besides, All-Ka Multiflex conveyor chains normally in food cans, glass products, milk cartons, as well as the bread conveying. The different type can be available as your requirement, thus as long as you give me the drawing or detailed specification, everything is okay. So All-Ka has the products to suit any customer requirement.
Product detail pictures:
That has a positive and progressive attitude to customer's fascination, our enterprise constantly improves our merchandise high quality to meet the demands of customers and further focuses on safety, reliability, environmental requirements, and innovation of China Wholesale for The Har-1400 of multiflex conveyor chains to Japan Manufacturer, The product will supply to all over the world, such as: New Orleans, British, San Francisco, now we have all day online sales to make sure the pre-sale and after-sale service in time. With all these supports, we can serve every customer with quality product and timely shipping with highly responsibility. Being a young growing company, we might not the best, but we are trying our best to be your good partner.
https://www.how-to-repair.com/help/repair-guides/washing-machines/heating-systems-washing-machines/
washing machine not heating, We are going to show you how to fit the new element and thermostat to this Bosch, Neff or Siemens washing machine this process should be pretty similar to your make and model of front loading machine.
Safety first disconnect your washing machine from the power supply and it’s a good idea to turn the washing machine water supply of,
1. Remove two screws from back of the top panel. These are normally torx head screws and you can get a full set of these torques bits in our tool section.
2. Take out the soap dispenser draw by pressing the button on top.
3. Remove front panel after removing screws, do keep these screws separate because they’re stainless steel.
4. Remove the kick strip and pump flap normally one screw.
5. Remove this retaining clip which is holding the door seal against the machine. There are lots of different ways that these retaining clips work, see video.
6. Remove screws that are now holding the front panel of machine on.
7. Remove door interlock, two screws.
8. Peel back door seal after taking the retaining clip of. See video
9. The element is situated at the bottom of the drum. Take photo of the wiring before disconnecting it.
10. Just uncouple the wires attached to the thermostat. Usually block connector.
11. Undo this nut which is attached to the retaining clip, with a spanner or a socket. Don’t undo it all the way because you have to tap the nut in, to release the pressure on the seal, then with a flat bade screw driver prise the washing machine heater element away from the outer tube. Be careful with this
12. The thermostat is a push fit into the element
13. If you need to check if the element has blown you will need to use a multi-meter to test it.
14. Replace which part is need and reverse this procedure
By Diana from Guinea - 2016.10.25 15:53
This is a very professional and honest Chinese supplier, from now on we fell in love with the Chinese manufacturing.
By Lillian from Mumbai - 2016.10.23 10:29
